Instructions, in depth.
Everything you need to start, restore safely, and get the most from your Priva device. Written for the long journey.
Getting started.
Foreskin restoration is the gradual expansion of penile shaft skin through sustained, gentle tension. It is not fast, and it isn't supposed to be, skin grows in response to tension over months and years, not days. Patience and consistency outperform aggressive tension every time.
Three principles, before anything else:
- Gentle is better than tight. The skin should feel stretched, never pinched or pulled white.
- Consistency beats intensity. Several short stretches of wear across the day outperform one long, painful one.
- Listen to your skin. Redness, irritation, or numbness means stop. Rest days are part of the protocol.
The CI stage scale.
The Coverage Index (CI) is the community-standard way to track progress, running from CI-1 (fully retracted at rest) to CI-9 (full coverage with overhang). Knowing your stage helps you pick the right device and tension level.
- CI-1 to CI-3, Early. Little to no slack. Focus on building initial skin available for gripping.
- CI-4 to CI-6, Mid. Some flaccid coverage. The widest range of devices works well here.
- CI-7 to CI-9, Late. Full flaccid coverage. Focus shifts to refinement, inner skin development, and dual tension.
Priva Air
Direct Air - Designed for efficiency and control, the Priva Air delivers direct inflation exactly where it’s needed, helping you maintain consistent pressure and achieve optimal restoration results. Quick Connect Valve - Add air to your device using the included...
Start soft (30A perforated). Move to the firm 45A once your skin tolerates more pressure.
The denser inner cone goes over the glans; the softer outer cone seals against the skin.
Attach the one-way quick-connect valve. Squeeze the bulb slowly.
Stop the moment you feel firm pressure, not pain. Hold the inflation for 10–20 minutes.
Slowly release the valve. Skin should be pink, not red or numb. Wait at least an hour before repeating.
Priva Packer
Priva Trio Includes a magnetic retainer that can be used as a tugger and a packer it includes a 30A solid gripper and a 30A perforated gripper
Priva Duo
Dual tension packer extendable with magnetic plates Adjustable tension Tension indicator *extension plates not included*
Start with the perforated 30A gripper while you adapt, then move to a firmer gripper once your skin tolerates more.
Bring existing slack forward over the glans, roll the foreskin onto the bell and seat the gripper so the skin is held securely.
With the pusher resting against the glans, engage the spring-loaded rod. It ratchets out in steady increments, applying dual tension, drawing the skin forward while pushing back against the glans, and holds each position so the tension stays set without a manual grip.
Advance the rod one increment at a time and read the built-in tension indicator. Aim for steady mid-range pressure you can repeat, not maximum.
Stack 10mm magnetic plates to extend length as you progress. Start with 30–60 minutes at a time, increasing slowly. The Duo is suited to longer wear once you adapt.
Priva Tugger
micro texture TPU for superior grip swappable grippers accessory ring vent for targeting tugging
Care & cleaning.
- Wash with warm water and mild, fragrance-free soap after each use.
- Air-dry fully before storing. Trapped moisture degrades silicone over time.
- Avoid oil-based lubricants on silicone, they break down the material. Water-based only.
- Inspect grippers regularly for nicks or stiffness. Replace as needed.
Troubleshooting.
The device keeps slipping
Usually a gripper-size issue. Try the perforated gripper for more friction, or move to a softer 30A if the 45A is too rigid to seat properly.
Skin is red or irritated after wearing it
Tension is too high or wear time is too long. Cut both in half and rebuild gradually. Take 1–2 rest days.
Numbness or cold sensation
Remove immediately. Restricted circulation means tension is too tight. Wait until full sensation returns before reapplying, at much lower tension.
Inflation won't hold (Priva Air)
Check the one-way valve is fully seated and the gripper is making a complete seal against the skin. A thin layer of water-based lubricant on the seal can help.